Peugeot Boxer/Citroen Relay/Fiat Ducato LPG tank kit

£390.00 ex. VAT

Out of stock

SKU: G-076 Category:

Description

This chassis  is shared by three manufactures vehicles,  namely the Fiat Ducato,  Peugeot Boxer and Citroen Relay.  Its wide choice of engines, great drivability and keen pricing, plus its ready availability in the used van market means it is a firm favourite for both the professional and home build van converter.

For those who wish to install a refillable underslung LPG tank, and do not have any desire to become an expert at identifying all the different components required to complete an installation, then this Gastore Kit is for you and will provide you with everything from the cap on the fill point through to the regulator.  The kit also contains our unique low current, micro processor, CE approved, gas controller/display that allows the gas flow and level to be controlled from inside the vehicle.

The 25 litre tank fits in the space behind the vehicles exhaust silencer and will bolt up using existing hole positions in the stronger chassis members rather than thinner floor metal.   So no drilling required.  The front mounts double up with the silencer mounting brackets and the rear ones go up using the supplied nutserts.  Simple !!! .    The tank is then offered up and bolted to these Stainless Steel cross members.

Citroen Relay LPG mounting

Once the tank is in place you can look at mounting the fill point. this generally goes through the body at the base of the drivers side B pillar but can go wherever suits. A sill mounted version is also available upon request. The kit contains 3 metres of fill pipe to allow for easy routing up and over exhaust shields, through chassis members etc…

Hanging from the tank valve will be two wires 5.5 metres long,  one for the electronic solenoid, the other to the environmentally sealed level sender.  These cables can be run up to the inside of the vehicle and connected to the supplied double fused junction box along with the 12v feed from your leisure battery.  Mount the Gastore power saver solenoid control/display in your desired position and connect to the junction box.

The outlet of the tank can be connected to regulator pre installed to the n/s mounting bracted and you are ready to connect your appliances on the low pressure side……

 

This kit fits third generation chassis 2006 – present.  Always pre-check your vehicle to ensure no water tanks or side steps etc interfere with this space.

So what’s included.

25 litre tank

LPG vapour phase multivalve with electronic solenoid and level sender to 2014/68/EU (PED)

Stainless steel mounting brackets

Standard UK bayonet filler in ‘through body’ housing

3 metre high pressure 8mm fill hose

Cavagna 28 – 30 mBar regulator with GOK test nipple.

0.75 metre pigtail

internal level and solenoid GASTORE CE approved controller

Double pole fused junction box

5.5 metres of solenoid cable

5.5 metres of level sender cable

4 x M10 Rivnuts

4 x M10 x 25mm stainless steel fixing bolts

4 x M10 spring washers

2 x 16mm P clips

Installation and operating instructions

Tank/Valve/Regulator compliance certificates

Birth Certificate and log card.

Technical

Tank – 25 litre capacity @ 80% fill 20 litres or 10kg LPG

Weight 18kg Dry  –  28Kg full

All bracketry manufactured using min 3mm thick Stainless Steel

Gas Control 12v @ 1A for 2 seconds then 3V @<100ma continuous

Full installation exceeds requirements of UKLPG CoP 11